Screw driver

About this device
Keywords 3D printing, hand tools, screw driver, construction
Uses development, industry
Authors Bryton Hutchings
Status Open design
Made? No
Replicated? No
Designed in United States
SDGs SDG08 Decent work and economic growth
SDG09 Industry innovation and infrastructure
Documentation data
Language English
Manifest data
Language English
Updated 2020-06-04
Author Kathy Nativi
Author affiliation Appropedia
Author email info@appropedia.org
This Open Source Appropriate Technology has been designed but not yet tested — use at your own risk.

Screw Driver

Components

Abstract

  1. With this design I always see screw drivers being made, however I wanted a simple design of a screw driver but also allowing me to store bits in the design.

Bill of Materials

    1. RepRap 3D printer ($500)
    2. PLA filament (1 spool - $25)
    3. screwdriver bits ($7.97)- http://www.amazon.com/gp/product/B000HLGPFG?keywords=screwdriver%20bits&qid=1447944686&ref_=sr_1_3&sr=8-3

Tools needed for fabrication of the OSAT

  1. MOST Delta RepRap or similar RepRap 3-D printer
  2. Elmers Glue Stick

Skills and Knowledge Necessary to Make the OSAT

  • No special skills required

Technical Specifications and Assembly Instructions

  1. Provide directions for print/assembly - be detailed enough in your “how to” to ensure that someone could construct the device from your description. Consider the elegance of IKEA like instructions.
  2. time estimate 2 HOURS
  3. 5 minutes

Common Problems and Solutions

  • some problems are the hole for the end bit
  • and cap correctly fitting

Cost savings

  • If your solution is not a low cost one then it is not really appropriate.
  1. 48grams = $1.20
  2. $15.07 commercial equivalent - Screwdriver Sets: Klein Toolss 5-Piece Magnetic Screwdriver Set 70035
  3. 15.07-1.20=13.87
This article is issued from Appropedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.